Boonton PIM 31 Remote Control User Manual
Page 4
1.2 Using PIM31 Remote Application:
Before using the remote application the following default settings for both IP
address and port number need to be verified.
1.2.1 Enter IP address and Port
Open the “PIM31 Remote Control” software from desktop
Verify that the IP Address is same as PIM31:
Default : 192.168.0.10
Enter Port 3100
1. Press”Connect” button.
The “Equipment Get” buttons is now enabled
2. With proper connection PIM31 should now show “Remote Control” on its
screen
3. Press “Equipment Get” button.
The model is now shown in the Equipment field and the settings of equipment
are shown as well.
4. Change settings by overwriting the relevant fields and push “Set” button.
5. Pressing “RF ON” activates the RF and measurements are done automatically.
6. “RSSI” can be pushed while RF is off