Boonton PIM 31 Quick Start - Manual (Page 3)

Safety and Caution Summary
SAFETY:
• INSTRUMENT MUST BE GROUNDED (must be connected to an electrical ground
at the power outlet)
• DO NOT OPERATE THE INSTRUMENT IN AN EXPLOSIVE ATMOSPHERE
• KEEP AWAY FROM LIVE CIRCUITS
• DO NOT SUBSTITUTE PARTS OR MODIFY INSTRUMENT
• NON IONIZING RADIO FREQUENCY RADIATION HAZARD
• ELECTRIC SHOCK HAZARD
CAUTION:
• Please check the power requirements as per the product specifications.
• Ensure at least 2” of clearance around the fan intake on the front panel and
bottom vents.
• Before powering the unit on make sure there are no indications of exposure
to extensive force suck as dents, torn off pieces or loose parts in the case.
• DO NOT touch connectors of components with bare fingers.
• DO NOT switch on RF power without a load or antenna attached.
• DO NOT operate the PIM31 in an active system.
• DO NOT connect or disconnect any component of the test setup with RF pow-
er switched on.
• DO NOT operate test system and load without connector savers.
• DO NOT mount components directly on the PIM31.
• DO NOT bend cable tighter than 40 cm / 16” of diameter.
• DO NOT over-torque the RF Port connector and accessories.
• DO NOT use sharp devices on the touch screen.
• To maintain the optimal performance of the PIM31 unit, prevent exposure
to unnecessary force, keep accessories clean and dry, and regularly check for
wear and tear.
PIM31 Series Packing List
The following standard items are included with the unit :
• PIM 31 Series Passive Intermodulation Test System
• Line Cord with 90 degree connector
• USB mouse and USB roll-up keyboard
• 3 connector savers
• Low PIM cable 3m (10ft)
• Low PIM load 50W
• Torque wrench