AVerMedia Technologies AVerKey300 - Manual (Page 9)

6
Chapter 2
Hardware Installation and
Setup
This chapter will show you how to install the AVerKey
300
to an IBM
compatible PC, Macintosh computer and NEC PC.
Connecting AVerKey300 to the
Computer and Monitor
The ports on the back panel of the AVerKey
300
are for connecting the
converter to the system unit and graphics display monitor. The figure and
descriptions below specify what device should go into each port. (Text
describing each port are printed at the bottom side of the converter.)
POWER (7.5V) : Plug the AC Power Adapter to this port.
VGA IN : For IBM PC or compatible :
This port connects the AVerKey
300
to the
IBM compatible PC’s VGA port via the supplied
Computer Extension Cable.
For Macintosh or NEC computer :
This port connects the AVerKey
300
to the
Macintosh/NEC PC’s display card via the