Clinton Electronics CE-T909 - Manual

Included Items:
• Camera x 1
• Allen Wrench x 2
• Instructions x 1
• Phillips Head Screws x 3
Required Items:
• Phillips Head Screwdriver
Optional Items:
• CE-REMOTE
• Drill w/ Phillips Head Bit
To ensure quality operation, verify proper BNC and power termination; along with proper
voltage at camera.
TO DVR/MONITOR TO CAMERA
BNC CONNECTION
POWER CONNECTION
T909
1. DISASSEMBLE
2. CAMERA MOUNTING
4. REASSEMBLE
INSTALLATION GUIDE INSTALLATION GUIDE
3. ATTACH CABLES
a.
Place the camera body into the socket of the mounting plate. Then place the outer
plate over the camera body and mounting plate. Loosely tighten the set screws to hold
the camera together.
SET SCREW
MOUNTING PLATE CAMERA BODY OUTER PLATE
Affix the mounting bracket to the surface with the 3 supplied Phillips head screws. Feed the cable from the camera through the center of the mounting plate. Make connec-
tions to the BNC cable and the power connection. Feed any cable slack into the
mounting surface.
a.
With the supplied Allen wrench, loosen the 2 set screws located on the outer plate.
b.
Carefully seperate the mounting plate from the outer plate and camera body.
b.
Remove the protective film over the lens.
v.05.29.13
The set screws will be tightened after camera adjustments are made.
*Information in this document is subject to change
Clinton Electronics