Clinton Electronics CE-VXRMB - Manual (Page 2)

Align the tab with the slot when reassembling.
Replace the four screws that hold the camera assembly to the base.
Note: Arrowheads indicate screw location.
Arrowhead indicates
screw location.
Adjustment:
The Vandal X Dome Camera has four position adjustments:
A. Barrel rotation
B. Lens angle
C. Lateral adjustment (loosen thumb screws on each side to adjust)
D. Camera plate rotation (pinch the camera bracket by each thumb screw to
rotate clockwise or counterclockwise)
Testing:
Before replacing the dome cover you may wish to test the camera with a test
monitor. To test, plug in the CE-REMOTE into the DIN connection shown below
and connect your test monitor to the BNC connection located on the CE-REMOTE
cable. Refer to camera manual for detailed OSD adjustment settings.
for OSD Adjustment & Test Monitor Connection compatibility.
Tighten the 3 Torx screws that hold the dome cover onto the base to complete
installation. Make sure that each screw is tight to ensure superior weather resistance.
UP
DOWN
RIGHT
LEFT
A
B
C
D
3. Mounting the Camera
Feed the power and video cables through the hole marked
“CABLES GO HERE”.
NOTE: Due to the replacement of the bottom case, a 1/16” gap between the
VXRM and the VX camera dome will result. This will not affect the IP68 weather
rating of the VX series camera.