Cyron Lighting MLK Kits 2011 - Manual

Thank you for choosing CYRON products! At CYRON we are
committed to provide the latest lighting technology without any
compromises.
To install this kit you should be familiar with basic electrical
wiring. Should you need help installing the system you may
contact CYRON customer support at 818-772-1900 x106 or
[email protected]. Alternatively, you may seek help from
your local motorcycle shop for installation.
TOOLS NEEDED:
Wire stripper, Wire cutter, Electrical tape, Crimper may be used. NOTE: Soldering is not necessary with the use
of CYRON solder-less terminal blocks. Alternatively, you may choose to solder and shrink tube the connections.
INSTRUCTIONS:
Never work on the bike with a hot engine
Pay special attention to placement of the wires. Avoid moving parts or coming in direct contact
with the engine. Use wire ties to secure all the wires.
The Solder-less Terminal Block provided makes five simple and secure connections. Once all
connections are made, it is a good idea to cover the terminal block with electrical tape for
additional protection from the elements.
1. Battery:
Locate the positive (+) and negative (-) battery posts.
2. LED Placement:
Choose locations where the light does not
get blocked by other objects. Shine light on the chrome parts
to maximize the effectiveness of the LEDs. See picture
below for some suggested areas. Take extra care so as the
lights do not disturb yours, or other driver’s night vision.
3. Cleaning:
Wipes have been provided to clean the LED
bodies (where the tape will be put) and the installation area
free of grease and dust.
a
Before proceeding make sure the wipes do not effect
the painted surfaces.
Wipe the area and let it dry completely.
4. LED Attachment
: CYRON CV6 LED can be mounted on its side or back. Choose one or the other
depending on the installation area and direction the light needs to project. Extra tape has been provided in case
you decide to reposition the lights. Remove one side of the tape liner and place on the LEDs. Remove the other
side of the liner (you may need a thin sharp object such as a knife to gently remove the liner) and place the lights
in the designated areas. Avoid touching the adhesive surface.
5. Solder-less Terminal Block:
Solder-less terminal blocks have been
provided to eliminate the need of
crimping tools or soldering. Strip the
wires half an inch. There are five slots
on each Terminal Block. With the
orange lever lifted all the way (90º), a
single wire or a combination of few
wires twisted together can be inserted
in the slot. Closing the lever will
secure the wire(s) in place. The order
of connecting wires in the five
openings does not matter. All five
openings of the terminal block are
electrically the same.