Cyron Lighting HT1502W2 - Manual (Page 2)

Cabinets, Shelving, Furniture: Typical locations are: Top or bottom of the cabinets, behind furniture trimmings, on the shelves,
and behind glass covers. Same general locations work well for most objects. There are many ways to backlight and accent light.
Try various positions to achieve the desired results.
CLEANING
a
Using the wipes provided test a small area to make sure it does not affect the mounting surfaces. Clean the
installation surfaces free of dust/grease to assure the two-sided tape adheres well.
3. MOUNTING CLIPS Mounting clips can be secured using the two-sided tape or screws. DO NOT USE SCREWS FOR
FASTENING TO ELECTRONIC DEVICES AND SENSITIVE SURFACES.
CAUTION: Tapes may cause discoloration to some surfaces over time. Remove one side of the tape liner and apply to the bottom
of the clips. Apply pressure for 5 seconds to assure adhesion. Place clips on the light bars.
4. LIGHTBAR PLACEMENT Remove the second side of tape liner. Keep the tape surface clean. Place the bars in the proper
location by pressing on the clips for 5 seconds. CAUTION: Never press on the clear lens of bars. Light bars will get damaged!
Note the direction of the wires being routed to the hub.
5. HUB Mount the hub using screws or tapes. Plug the light bar connectors into
hub outlets. The plugs are polarized and can only be plugged in one direction.
6. CONTROLLER Use tape to mount the controller in an accessible location.
Some painted surfaces may get damaged upon future removal of the
tape/controller.
7. POWER UP Plug the power supply into an AC outlet. The plug is polarized
(one blade is wider than the other) as a feature to reduce the risk of electric shock.
This plug will fit in a polarized outlet only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does not fit, contact the factory or a
qualified electrician. Never use with an extension cord unless the plug can be
fully inserted. Do not alter the plug.
8. DC JACK Connect the DC power jack into the controller DC cord.
Operations
Turn the unit on and adjust the light angle by twisting the light bars within the brackets. Try several angles to achieve the desired
results.
Operation of HTW202 controller is simple. Color buttons on the remote correlate to the colors displayed.
Four different color shows STROBE, STEP, FADE, and COLOR automatically change light colors and patterns
with pre-programmed sequences.
1. The speed of light can be changed using the Up and Down buttons. There are 5 different speeds