Cyron Lighting OLS14 - Manual

OLS14F / OLS18F
Outdoor Accent Light System
Thank you for choosing CYRON products! At CYRON we are committed to
provide the latest lighting technology without any compromises.
Please read all instructions and follow carefully .Should you need help you
may contact CYRON customer support at 818-772-1900 x106 or
[email protected]. Alternatively, you may seek assistance from an
authorized CYRON dealer near you.
COMPONENTS:
1 x strand (4ft OLS14F, 8ft OLS18F) 1 x Extension cord, 25ft 1 x Controller box
1 x Remote control key fob 2 x Velcro strap (packaged with extension cord)
TOOLS NEEDED:
None
OVERVIEW:
CYRON Outdoor Accent Light System is primarily used for illuminating outdoor environments where a 12VDC source is
available. It is great for campsites, tailgate parties, boating, RVs, and much more.
CAUTIONS:
Keep controller in dry location.
Do not pull with force on the light strand.
Remove light before vehicle is underway.
Do not submerge any part of this lighting system.
a
Do not use during lightning storm. Extreme chance of injury and electrocution.
INSTRUCTIONS:
1. Connect Wires:
Connect strand to extension cord. Press male & female ends completely together. Thread the retainer
ring. Do not over tighten. Connect other end of extension cord to the controller.
2. Secure Wire:
Secure light and wire with Velcro strap provided. NOTE: The strap is packaged with the extension cord.
When mounting on a flagpole, wrap the wire around the pole three turns to minimize slack in the wire.
3. Power source:
Connect controller to a 12VDC source. Connect the wire with fuse holder to +12VDC. Connect the
other black wire (coming out of the box with the positive lead) to the -12VDC. Do not make any electrical connection
to the thin black lead. This is the antenna for the RF signal.
4. Controller Placement:
You may choose to leave controller permanently connected to one the batteries on your vehicle.
In such case it is highly recommended to remove the fuse from fuse holder when CYRON system is not being used.
Keep controller out of dust, dirt, liquids and other elements. You may choose to better protect the controller by
wrapping electrical tape around the housing and wire openings.
Attach a small magnet to the back of the controller so you can simply place it on the underside of any metal surface to
protect in case of rain. Don’t forget to remove controller before you get on the road!