Audiovox CNP2000UC User Manual
Page 7
7
Installation Procedure
Step 3
Start your car and turn on your unit to confirm that the XM Direct system is
properly connected. When you tune to XM channel 1, you should see “XM
Preview” on your head unit LCD, and hear that channel through your car
speakers. If not, check to make sure all connections are correct or refer to the
troubleshooting section of this installation guide.
Step 4
Mount and secure the PIA
in a suitable location that will not interfere with
the radio and will not vibrate or rattle after installation.
Step 5
Return the car stereo head unit back to its original location in the dash board,
be careful with cables that you just installed so that they do not unplug or
get kinked by the head unit.
Note: If you had removed screws to pull the car stereo head unit out
please screw those back in.
Step 6
If you had removed the dash board during installation please return it back
to its original location.