Demon Fuel Systems 421441 - Manual (Page 5)

5
10. Install the manual choke pod assembly. Use one of the 1-3/4" SHCS with a #8 lock washer in the upper left
mounting hole to hold the pod in place while you make the other connections. Insert the end of the choke
rod through the hole in the end plate of the pod, with the end of the plastic cam above the rod where it
comes through the hole in the bracket.
Use the 1/2” retainer pin to secure the choke rod in place (Fig. 12).
Install the rest of the 1-3/4" SHCS with a #8 lock washer on the upper right hand portion of the choke pod
(leave the bottom left mounting screw out at this time). Before tightening the mounting screws open the
throttle linkage with the primary throttle linkage and push the adjuster on the side of the choke pod forward.
The choke flap shop should be open to the vertical position and the fast idle speed screw should be in-line
with, but not touch the plastic fast idle cam (Fig. 13). If it does not align with the cam it may be necessary to
slightly bend the bracket to line it up properly.
Figure 12 Figure 13
Figure 14
Note: The choke linkage will only close when you depress the throttle. If you try to close the choke
flap without depressing the throttle you can damage the linkage.