EOTech XPS2-RF User Manual
Page 3
MOUNTING
The XPS2-RF™ is equipped with an integrated base designed to attach to a 3/8”
(9.5mm) dovetail rail. To achieve the best results and accuracy, the HWS® must be
mounted properly. To mount the sight, please follow these steps.
1.
Turn the two cap screws counterclockwise to back
out weaver lock. Do not back the bolt all of the
way out of the lock, only enough for the base to sit
properly on the rail.
2.
Turn the set screws clockwise, drawing the weaver
lock into the rail until the screw head is flush to the
weaver lock.
3.
Using the 1/16 allen tool, rotate the cap screws an
additional 1/2 turn to fully tighten. This is equiva-
lent to approximately 6 in-lb (0.07 kgm) of torque.
Note: This model is not intended or warranted for use
with calibers other than .22LR or smaller .