EOTech NEW 512 Laser Battery Cap - Manual (Page 4)

Visible Laser
Aperture
Remote Pressure Switch Port
Adjustment Tool
Elevation Adjustment
Windage Adjustment
(IR Laser)
On/Off Switch
(IR Laser)
On/Off Switch
(Visible Laser)
IR Laser Aperture
Windage Adjustment
(Visible Laser)
Dual Laser Shown
Installation
cont’d
Step 8 - Once the cap is seated properly, slowly press down the battery latch
until it is seated flush with the top of the cap.
Step 9 - Turn on the visible laser to ensure the cap is on correctly.
Zeroing the LBC
To zero the LBC, follow these easy steps.
Step 1 - Zero the 512/552 using the guidelines highlighted in the user manual.
Step 2 - Once the HWS is zeroed, turn on the LBC visible laser and align the laser dot
with the 1MOA aiming dot in the HWS using the windage and elevation adjustments.
a. Remove the adjustment tool on the back of the on/off switch
by turning counterclockwise.
b. Use the adjustment tool to make the necessary zeroing corrections.
c. Turn the windage adjustment clockwise to move the laser dot left.
d. Turn the Elevation adjustment clockwise to move the laser dot up.
e. Return the adjustment tool back to its storage location
and tighten by turning clockwise.
NOTE: The IR laser will require a night vision device to see the laser. Follow the steps above to zero this laser.
NOTE: Minor adjustments to realign the laser to the HWS dot may be required if at anytime
the LBC is removed from the base.
NOTE: Zeroing the LBC for CQB applications inside 25 yards may require the
laser to be offset slightly from HWS aiming dot.