Equus 3160 - ABS/SRS + OBD2 Scan Tool - Manual (Page 52)

Live Data Mode
RECORDING (CAPTURING) LIVE DATA
50 OBD2
1.
With the Scan Tool in "Live Data" mode
(see VIEWING LIVE DATA on page 47
for details), press and hold the
ENTER/LD
button until the "Mode
Selection Menu" appears.
2.
Use the UP
and DOWN buttons,
as necessary, to highlight “Live Data
Menu”, then press the ENTER/LD
button.
„ The "Live Data Menu" displays.
3.
Use the UP
and DOWN buttons,
as necessary, to highlight “Record Live
Data”, then press the ENTER/LD
button.
„ The "Record Live Data Menu" dis-
plays.
4.
Use the UP
and DOWN buttons,
as necessary, to highlight Record by
DTC trigger, then press the ENTER/LD
button.
5.
When the "Record by DTC Trigger" screen displays, select the
desired trigger point as follows:
The Scan Tool is capable of recording approximately 20
frames of Live Data. Record by DTC trigger lets you select the
point in time at which you wish the Scan Tool to begin
recording Live Data. You can set the trigger point to record the
20 frames of data before an event (when the DTC sets), after
the event, or in the middle (10 frames before and 10 frames
after the event.
„ Beginning - records approximately
20 frames of Live Data after the
DTC sets.
„ Middle - records approximately 10
frames of Live Data before and 10
frames after the DTC sets.
„ End - records approximately 20 frames
of Live Data before the DTC sets.
6.
Use the UP
and DOWN buttons,
as necessary, to select the desired
trigger point, then press the ENTER/LD
button.
„ A "One moment please. . ." message
shows on the display. When the Scan
Tool is ready to record Live Data, the
"Record Live Data" screen displays.