AeroComm ConnexModem Version 2.0 - Manual (Page 8)

ConnexModem & ConnexPC User’s Manual
8. You are now ready to configure the new modem. Select “Standard 56000 bps K56Flex
Modem” and then click Properties.
9. On the General tab, select the port that is connected to the ConnexLink unit. Select
115200 for the Maximum speed. Do not select “Only connect at this speed”, as this
will not allow communications from the ConnexLink unit to the ConnexModem unit. The
selected Baud Rate must match the ConnexLink’s Baud Rate setting.
10. Click the Connection tab. Select 8 Data bits, None for Parity, 1 for Stop bits. Select
“Wait for dial tone before dialing”. Selecting “Cancel the call if not connected
within xx secs” is optional.
5/25/2004 8