ididit Steering Wheel Adaptor: 1963-66 & 68 Corvette Adaptor - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
1963-66 & 68 Corvette Adaptor with Spacer Kit
For Part Number’s 2202350020, 2202350030, 2202350040, 2202350051
Instruction #: 8000010003 REV 01/13
1. If your wheel has the layered third spoke (Figure 2)
you will need this spacer kit. (Figure 3)
2. With the horn hole of the adaptor in the 10:00
position, lay the spacer on the top of the adaptor
with holes lined up.
(Figure 4)
3. Now set the wheel on top of the adaptor (Figure 5)
with the layered spoke sitting in the cut out of the
spacer.
4. Install the (6) 10-32x3/4 flat head screws and
tighten. (Figure 6)
5. Insert spring into the white tube of the horn cam.
(Figure 7)
6. Turn this sheet over to find instructions on how
to install Horn Contact Pin.