ididit Cable Shift Linkage Kit: GM Column to GM Transmission - Manual (Page 10)

GM Column to 700R4 Trans - Before installation please read:
You will need at least 2” of clearance between the firewall and lower
shift lever for this product to function correctly.
Melted Cables: If your cable is too close to your exhaust it will melt or
become brittle. If this is the case you will need to make a heat shield. Do
not wrap the cable as this retains heat. Heat will destroy the cable.
Kinked Cables: Do not kink the cable anywhere along its length. If the
cable has a kink it will lock up. The cable should be kept straight for 2” on
each end where it leaves the brass. Either of the above could damage the
cable, shifter, and/or transmission in one shift.
Cable Adjustment: If you do not adjust the cable correctly you could
damage the cable, shifter and/or transmission. Put the trans in Low gear
and the shifter in Low gear, set the swivel so it slides in and out of the cor-
rect hole freely. Then move the transmission and shifter to Park (all the
way the other way). Rotate the cable swivel until it slips in and out of the
hole freely. Now go back and forth between Park and Low gear and fine
tune the adjustment. See instructions for further detail.
Your kit should contain the following parts:
A.) Transmission Levers*
(A1: 700R4 A2: 350/400)
B.) Spacers
C.) Cotter Pins
D.) Swivels
E.) Pan Bracket
F.) Shift Cable
G.) Two Piece Bracket
H.) Horseshoe Bracket
A1.
C.
B.
D.
E.
F.
G. H.
A2.
*The 700R4 transmission lever is labeled as 700 on the lever. The 350/400 lever is not labeled. A sure
way you are using the right lever is when the levers are facing the same way (flat, rounded end towards
your right) the 700R4 lever is beveled up and the 350/400 is beveled down.
9
Note: You will need to purchase 2 Transmission Pan Bolts 1/4” Longer