JELD-WEN JII036 Custom Swinging Screens - Manual (Page 3)

INSTALLATION INSTRUCTIONS
for Custom Swinging Screens (JII036)
3
©2012 JELD-WEN, inc.; This publication and its contents are owned by JELD-WEN, inc. and are protected under the U.S. Copyright Act and other intellectual
property laws. All trademarks, service marks, logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others.
Unauthorized use or duplication of JELD-WEN intellectual property is prohibited.
JELD-WEN reserves the right to change product specifications without notice. Please check our web site, jeld-wen.com, for current information.
(08/12)
Please visit jeld-wen.com for warranty and care and maintenance information.
Thank you for choosing
DOOR CLOSER INSTALLATION
1. For single entry and
double active door
screen only, with the
screen assembly closed,
place the jamb bracket
on the hinge side 1/4"
from the inside face of
the screen and locate
it vertically on the
approximate center of
the screen frame top
rail.
2. Mark the screw hole
locations and drill
1/8" pilot holes where
marked. Install using
#10 x 1" black screws.
3. Slide the hold-open
bracket onto the closer rod over the lugs until against the closer tube.
Align the closer rod hole with the jamb bracket hole and attach with
the short pin. Attach the screen bracket to the closer tube FRONT hole
with the long grooved connecting pin.
4. Close and latch the screen assembly. Hold the door closer level and the
screen bracket against the screen assembly, mark through the center of
the slots and drill two 1/8" pilot holes through only the inside surface.
Attach the bracket to the screen assembly with #10 x 1/2" short black
screws. Reattach the closer to the screen bracket in the REAR hole of the
closer tube (if the screen includes an optional glass panel to interchange
with the screen panel, install the pin in front hole for best operation).
5. Open the screen assembly and move the hold-open bracket back of the
lugs on the closer rod. Closing speed may be changed by turning the
adjustment screw clockwise to slow the speed and counter-clockwise to
increase the speed.
SCREEN PANEL REMOVAL (FOR STORAGE OR INTERCHANGING PANELS)
1. With the screen
assembly closed, press
outward on the top
end of one side panel
retainer strip and
gently pull the top end
out and away toward
the center of the
screen panel (it may be
necessary to insert a
slotted screwdriver or
other flat tool between
the screen frame and
the retainer strip).
Work the strip out a
few inches at a time to
keep from buckling it.
2. Repeat the process on the opposite side, top and bottom retainer strips.
3. Remove the screen panel.
4. Install the optional storm panel by reversing the removal instructions.
5. To reinstall the screen panel, position the panel with the screen spline
facing into the house and install the top and bottom retainer strips first,
then sides. Center each in the door frame rail and begin at one end and
press into the rail all the way across a few inches at a time.
Screen
bracket
Screen
rail
Jamb
bracket
Adjustment
screw
Retainer
strip
Hold-open
bracket
Long pin
Short pin
Screen
assembly