King of Fans Cressner - Manual (Page 8)

of the motor housing (Figure 7).
Carefully insert the hanger pin through
the holes in the collar and downrod. Be
careful not to jam the pin against the
wiring inside the downrod. Insert the
locking pin through the hole near the end
of the hanger pin until it snaps into its
locked position, as noted in the circle
inset of Figure 7.
7.
Re-tighten the set screws on the
collar on the top of the motor housing.
8. Adjust the decorative downrod
pipe and motor collar cover on the
downrod until they sit properly on the
top of the fan motor housing.
9.
Re-tighten the two set screws on
the decorative downrod pipe that were
loosened in step 3 (Figure 7).
10. Proceed to “Installing the Fan ”
section.
WARNING
FAILURE TO PROPERLY INSTALL
LOCKING PIN AS NOTED IN STEP 6
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
CHANGING THE DOWNROD
(OPTIONAL)
An extra 6 inch downrod is supplied
with the fan for close-to the ceiling
installation, please see following steps on
5.
changing the downrod prior to
installation. NOTE: OMIT
DECORATIVE DOWNROD PIPE
WHEN USING THE 6 INCH
DOWNROD.
1.
Remove the hanger ball by
loosening the set screw at the top of the
12" downrod assembly which holds the
hanger ball to the downrod (This is not
the screw with green wire attached).
Slide the hanger ball down the downrod
and remove the support pin.
2.
Insert the support pin in the holes at
the top of 6" downrod and slide the
hanger ball up to the 6" downrod. Make
sure the support pin is properly seated in
the grooves in the top of the hanger ball.
3
ˊ Tighten the set screw firmly.
Installing Fan to the
Electrical Box
CAUTION
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. THE
MOUNTING PLATE MUST BE MOUNTED SO
THAT THE SLOT OPENINGS ARE ON THE
LOWER SIDE BY SLIDING THE MOUNTING
PLATE FROM THE TOP DOWN
1. Pass the 120-volt supply wires
through the center hole in the ceiling
mounting plate as shown in Figure 8.
2. Install the ceiling mounting plate
on the electrical box, sliding the
mounting plate over the two screws
provided with the outlet box. Note that
the flat side of the mounting plate is
toward the electrical box.
Figure 8
Standard Mounting
Figure 9