Lokar Tuned-Port Brackets - Manual

Building American Quality… With A Lifetime Warranty!
General Installation Notes:
Please read instructions completely before beginning installation. If you
have any questions please call.
Before starting installation, scotch vehicle tires to avoid accidental
movement of the vehicle. Disconnect negative battery cable before
beginning installation.
Make sure the engine, transmission, and frame are properly grounded.
We recommend applying anti-seize lubricant to all aluminum threads
before final assembly.
This bracket is designed to be used with a Lokar Throttle Cable, Kickdown Cable,
and/or Cruise Control Cable.
Refer to Fig. 1, Fig. 2, and Fig. 3 for the component names.
Step 1: Disconnect any existing throttle cable, kickdown cable, and/or cruise
control cable from the throttle body. If there is an existing throttle
cable bracket installed, remove it from the intake manifold plenum.
Step 2: DO NOT loosen the flat head bolt in the back of the Lokar bracket
or remove the cable stud from the mounting base. The cable stud is
precisely indexed to the mounting base, and it may be difficult to get it
reassembled in the correct position.
Install the Tuned-Port bracket onto the intake manifold plenum in the
original location, using the provided M6 x 16mm socket head bolts.
Step 3: Refer to the installation instructions for the Lokar Throttle Cable,
Kickdown Cable, and/or Cruise Control Cable. Remove the adjuster
nuts from the cable adjuster(s) that came with the cable kit(s).
Fig. 4
Replace those nuts with the smaller outside diameter TPI nut(s) that
came with this kit. Each cable adjuster gets only one nut. The flat
side of the nut should be facing towards the Tuned-Port bracket when
it is installed.
Fig. 5
Step 4: Thread the cable adjuster(s) for the throttle cable, kickdown cable,
and/or the cruise control cable into the Tuned-Port bracket. Adjust
the cable(s) as described in the installation instructions for the
individual cable kits.
Fig. 6
See Fig. 7 for a completed installation with a Lokar Throttle Cable
(not included) and Kickdown Cable kit (not included).
TOLL FREE 1-877-469-7440 • [email protected] • www.lokar.com
®
Tuned-Port Brackets Installation Instructions
Tuned-Port Brackets Installation Instructions
INS0150 Rev. 12/18/13 Page 1 © 2013 Lokar, Inc.
For Throttle Cable Only: For Throttle Cable and Kickdown Cable:
For Throttle Cable, Kickdown Cable and Cruise Control Cable:
Fig. 1 Fig. 2
Fig. 3
TPI Nut
TPI Nuts
TPI Nuts
M6 x 16mm
Socket Head Bolts
M6 x 16mm
Socket Head Bolts
M6 x 16mm
Socket Head Bolts
Tuned-Port
Bracket
Tuned-Port
Bracket
Tuned-Port Bracket