Warnings, Warning – Manley TAPE HEAD PREAMPLIFIERS User Manual

Page 5

Advertising
background image

WARNINGS

Your preamplifier has been factory set to the correct mains voltage for your country. The voltage setting is
marked on the serial badge, located on the rear panel. Check that this complies with your local supply.

Export units for certain markets have a moulded mains plug fitted to comply with local requirements. If your unit
does not have a plug fitted the coloured wires should be connected to the appropriate plug terminals in accordance
with the following code.

GREEN/YELLOW

EARTH

terminal

BLUE

NEUTRAL

terminal

BROWN

LIVE

terminal

As the colours of the wires in the mains lead may not correspond with the coloured marking identifying the
terminals in your plug proceed as follows;

The wire which is coloured GREEN/YELLOW must be connected to the terminal in the plug which is marked by
the letter E or by the safety earth symbol or coloured GREEN or GREEN and YELLOW.

The wire which is coloured BLUE must be connected to the terminal in the plug which is marked by the letter N
or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal in the plug which is marked by the letter L
or coloured RED.

DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER
CONNECTIONS HAVE BEEN MADE.

5

WATER & MOISTURE
As with any electrical equipment, these preamplifiers should not be used near water or moisture. If liquid enters the
preamplifier, it must be immediately returned to your dealer or the factory for servicing.

SERVICING
The user should not attempt to service the preamplifier beyond that described in the owner's manual. Refer all servicing
other than biasing and tube replacement to Manley Laboratories

SPECIAL NOTES
Tubes may become loose during transit. Straighten and press down each tube before plugging the preamplifier into the
mains socket. Furthermore, do not touch the tubes after the preamplifier has been switched on, as the tubes become very

hot during operation and should only be handled after the power has been turned off and the tubes have cooled.

WARNING!

TO PREVENT THE RISK OF ELECTRIC SHOCK

DO NOT OPEN THE CABINET

REFER SERVICING TO

QUALIFIED PERSONEL

!

Advertising