Manley MOVING COIL & MOVING MAGNET PHONOGRAPH PREAMPILFIER - Manual (Page 12)

MAINS CONNECTIONS
Your CHINOOK has been factory set to the correct mains voltage for your country. The voltage setting is marked on the serial
badge, located on the rear panel. Check that this complies with your local supply.
Export units for certain markets have a molded mains plug fitted to comply with local requirements. If your unit does not have
a plug fitted the colored wires should be connected to the appropriate plug terminals in accordance with the following code:
GREEN/YELLOW - EARTH
BLUE - NEUTRAL
BROWN - LIVE
As the colors of the wires in the mains lead may not correspond with the colored marking identifying the terminals in your plug
proceed as follows:
The wire which is colored GREEN/YELLOW must be connected to the terminal in the plug which is marked by the letter E or by
the safety earth symbol or colored GREEN or GREEN and YELLOW.
The wire which is colored BLUE must be connected to the terminal in the plug which is marked by the letter N or colored
BLACK.
The wire which is colored BROWN must be connected to the terminal in the plug which is marked by the letter L or colored
RED.
DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER CONNECTIONS HAVE BEEN MADE.
Note: 120 to 240VAC operation changeable with power transformer rewiring and fuse value change.
100VAC operation changeover achieved via rewiring of power transformer PCB.
Mains fuse value for 100-120V operation: 0.5A SLO-BLO
Mains fuse value for 220-240V operation: 0.25A SLO-BLO 5 x 20 mm
“Keep alive” transformer fuse for all voltage operations: 10mA MDL or MDA SLO-BLO fuse 1 x 1 1/4”
Waste Electrical and Electronic Equipment (WEEE)
Information for customers:
The European Parliament and the Council of the European Union have issued the Waste Electrical and Electronic Equipment Directive. The
purpose of the Directive is the prevention of waste of electrical and electronic equipment, and to promote the reuse and recycling and other
forms of recovery of such waste. As such the Directive concerns producers, distributors and consumers.
The WEEE directive requires that both manufacturers and end-consumers dispose of electrical and electronic equipment and parts in an
environmentally safe man-ner, and that equipment and waste are reused or recovered for their materials or energy. Electrical and electronic
equipment and parts must not be disposed of with normal household wastage; all electrical and electronic equipment and parts must be
collected and disposed of separately.
Products and equipment which must be collected for reuse, recycling and other forms of recovery are marked with the following pictogram:
Small products may not always be marked with this pictogram in which case this is present in the instructions for use, on the guarantee
certificate and printed on the packaging.
When disposing of electrical and electronic equipment by use of the collection systems available in your country, you protect the
environment, human health and contribute to the prudent and rational use of natural resources. Collecting electrical and electronic
equipment and waste prevents the potential contamination of nature with the hazardous substances which may be present in electrical and
electronic products and equipment.
Your MANLEY or LANGEVIN retailer will assist with and advise you of the correct way of disposal in your country.
5 x 20mm
Chinook Owners Manual 10
MANLEY
LABORATORIES, INC.