Manley LANGEVIN 150 WATT DUALMONOBLOCK AMPLIFIER - Manual (Page 5)

CONNECTING YOUR AMPLIFIER
Setting up your amplifier is rather easy.
1. Connect all source components (turntable, CD, Tuner, Tape DAT, etc.) to your preamplifier.
2. Connect the interconnects from the output of the preamplifier or switching center to RCA
input.
3. Connect the hot or "+" speaker cable to the top binding post and the common or "-" speaker
cable to the bottom binding post (See diagarm III). Ensure that the other end of the cable is
connected correctly to the speaker. Tighten the binding posts by hand. NEVER SHORT
CIRCUIT THE OUTPUT CONNECTORS!!!
4. Turn on Preamplifier and any source components you plan to use.
5. Ensure that the "mains" switch on the front panel is in the "off" or "0" position.
6. Plug amplifier into wall outlet.
7. Turn on amplifiers and enjoy.