MBRP S6224 User Manual
Page 3
6. Install the Hanger Clamp into the two OEM rubber hangers located above the outlet of the Muffler.
7. Install the Tail Pipe from the rear of the truck, over the axle and attach to the outlet of the Muffler.
Install tail pipe hanger into the OEM hanger to complete.
8. Install the provided clamps around pipes where needed. Adjust the Tail Pipe and check along the
whole length of the exhaust system to ensure there is adequate clearance around the fuel and brake
lines or any wiring. If any interference is detected relocate and adjust.
9. Make sure exhaust is in place before tightening clamps. Start at the front of the exhaust system and
begin tightening all connections.
10. If a tip has been purchased, install and adjust to suit. Using a 17mm wrench tighten lock bolt located
on the Tip. A Tip is not included with this kit. Tips may be purchased separately, check with your
dealer.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of
your MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
S6224 © 03/10
Page 3 of 3