MBRP S6204 - Manual (Page 3)

Installation of MBRP Inc. Performance Exhaust:
1. Install the Down Pipe in the same position as the stock down pipe and attach the flared end to the turbo
using the stock band clamp. Do not fully tighten until all components are in place.
2. Attach the Extension Pipe to the Down Pipe and place the hanger into the factory rubber insulator
located on the frame.
3. Install the Muffler over the Extension Pipe. Refer to the figure on the left
for
correct Muffler orientation.
4. Install the Tail Pipe from the rear of the truck, over the axle and attach to
the outlet of the Muffler. Install the hangers into the OEM rubber hangers
located above the outlet of the Muffler. Now install the Tail Pipe hanger
into the OEM hanger to complete.
5. Install the provided Clamps around the pipes where required. Adjust the Tail Pipe and check along the
whole length of the exhaust system to ensure that there is adequate clearance around the fuel and brake
lines or any wiring. If any interference is detected relocate or adjust.
6. Ensure that the exhaust is in place before tightening clamps. Start at the front of the exhaust system and
begin tightening all connections.
7. Install and adjust the Tip to suit. Using a 17mm wrench tighten lock bolt located on the Tip. A Tip is not
included with “INSTALLER” or “XP SERIES” kits. A Tip may be purchased separately, check with
your dealer.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of
your MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
S6204
© 01/06 Page 3 of 3