MBRP S4200 - Manual (Page 3)

S4200 © 08/13 PAGE 3 OF 4
2. Place a 3” Band Clamp over the Tail Pipe inlet. Slip the Tail Pipe inlet onto
the rear of the Over Axle Pipe. Install the hangers into the factory isolators. Do
not tighten ANY clamps until all parts are in place and aligned.
Refer to Figure 6.
3. Install the Extension Pipe, Gasket, and Hardware onto the factory down
pipe. The Extension Pipe has an angle built into it. Ensure that the pipe is
angled towards the passenger side of the vehicle. Place a 3” Band Clamp over
the Extension Pipe.
Refer to Figure 7.
4. Install the Muffler onto the Extension Pipe. Place a 3” Band Clamp over the
Muffler outlet. It is necessary to support the Muffler.
Refer to Figure 8.
5. Install the Resonator Assembly into the Muffler. Place a 3” Band Clamp
on the Resonator Assembly outlet and install into the Over Axle Pipe.
Ensure the 3” Band Clamp is located so it clears the heat shields and is
accessible to be tightened.
Refer to Figure 9.
Figure 6
Figure 7
Figure 8
Figure 9