MBRP S7240 - Manual (Page 2)

S7240 © 03/13 PAGE 2 OF 2
2011-2013 Mustang GT500 Axle Back Muffler Kit
Removal of Stock Mufflers
1. loosen the OEM band clamp at the muffler inlet joint on both mufflers.
Refer to Figure 1.
2. Remove the rear muffler hanger from the rubber isolator. Lower the rear of
the muffler and slide the muffler upward toward the front of the car to remove
from the front hangers. Repeat for the other side.
Refer to Figure 2.
.
Installation of MBRP Inc. Performance Exhaust:
1. Remove the OEM band clamp from the OEM Muffler assemblies by cutting
the retaining bracket. Slide the OEM clamps onto the MBRP Muffler
assemblies.
Refer to Figure 3.
2. Install the MBRP Driver and Passenger Mufflers by aligning the 2 front
hangers with the rubber mount on the car. Insert the hangers by sliding the
Driver and Passenger Mufflers upward toward the front of the car. Lift the
rear of the mufflers and install the rear rubber isolator.
Refer to Figure 4.
3. Position the over axle pipe into the muffler inlet pipes and secure with the
OEM band clamp.
4. Install the supplied Tips and align the system making sure that there is
clearance between all hoses and underbody components.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your
MBRP Inc. performance exhaust system. We know you will enjoy your purchase.
Figure 1
Figure 2
Figure 3
Figure 4