MBRP S7228304 - Manual (Page 3)

S7228 © 10/11 PAGE 3 OF 4
7. Remove the Pinch Bolt from the Steering Shaft and lift the shaft assembly
off the Steering Rack. Swing the shaft out of the way.
Refer to Figure 6.
8. Disconnect the Driver Side O2 Sensor lead from the vehicle wiring
harness.
9. Disconnect the wiring and remove the Starter Motor. Remove the Oil
Filter.
10. Remove the remaining M8 Flange Nuts securing the Exhaust Manifolds
to the Cylinder Heads from below.
Refer to Figure 7.
11. Remove the Oil Dipstick Retaining Bolt and Remove the assembly.
Remove both Exhaust Manifolds and the remaining M8 Studs in the
Cylinder Heads. Keep the Exhaust Gaskets, these will be reused.
Refer to Figures 8, 9, and 10.
12. Use a block of wood under the Oil Pan and CAREFULLY lift the
engine up off the Rubber Engine Mounts just enough to be able to
remove the Driver Side Engine Mount from the Engine Block.
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10