Avaya 1110 - Manual (Page 26)

Connect the components
26
Figure 3: Release the phone from the stand
Use the following steps to connect the components of your phone.
1. Remove the stand cover. Pull upward on the center catch (see
Figure 4) and remove the stand cover from the stand base. The
cable routing tracks are now accessible in the stand base (see
Figure 5 ).
WARNING Your Avaya 1110 IP Deskphone is shipped with its
stand locked in position. To release the phone from the stand,
press the Wall-Mount lever (see
Figure 3 ) and gently rotate
the phone away from the stand a little. When you’re sure the
phone is released from the stand, press the Tilt lever and fully
rotate the phone away from the stand.
Wall-mount lever