Poolmaster 72714 Classic Pro Water Basketball Game - Manual (Page 2)

A
ssembly I
nstr
uc
tions
2
poolmaster.com
Step 1
• Twist 8" Foam Floats onto Bottom Hoop Sections.
Step 2
• Place Tee Couplings on Bottom Hoop Sections making sure that pre-drilled holes face inside the
hoop (orient as shown).
Step 3
• Insert Uprights into Tees.
Step 4
• Secure bottom couplings and uprights with Set Screws.
Step 5
• Locate the red dot that states ‘Open End’ to allow the net to be installed properly by threading loops
around the Top Hoop.
Thread Net on PVC Hoop.
This is the net right out of the package.
You will be working with the longer looped end.
This is a close-up of the circled portion on diagram 1.
This is one loop.
Fold the loop toward you, creating two loops.
Insert your finger through the two loops.
Release the thumb holding the loop in place and pull
on the two middle strings. The loop should slide up
and catch your fingers.
Take the loop from your finger and slide onto the
basketball hoop. Continue this process with each
loop until all loops are on the hoop.
1
2
3
4
5
6
1 2 3
5 6 4
Step 6
• Insert top hoop couplings onto uprights and secure with set screws (holes located on inside of hoop).
Step 7
• Inflate game ball using Ball Needle and a hand pump (not included) to inflate Ball to “9” diameter.
Do not over inflate.
2
Set Screws
4
OPEN
END
5
6
1
Set Screws
3