Poolmaster 72783 Pro-Rebounder Poolside Basketball Game - Manual (Page 3)

A
ssembly I
nstr
uc
tions
3
Step 6
• Use Ball Needle and a hand pump (not included) to inflate
the Ball to 26 ½" circumference (approx. 8 ½" diameter).
Step 7
• Place "Warning! No Slam Dunking!" on base between
PVC Upright Supports.
poolmaster.com
• Remove the 2’’ pre-threaded Bolt from the U-Shaped
Upright and thread it through the front of the
backboard into the hole below the hoop bracket
and back into the bottom hole of the U-Shaped
backboard support and secure with hex nut.
• Attach the 3 ¼’’ bolt through the center hole in the
hoop bracket and into the top hole of the PVC
U-Shaped Support. Secure with hex nut.
Step 4
• Insert the U-Shaped Support into the Base. Fill Base
with water or sand and cover up opening with Cap.
• May need rubber mallet to push U-Shaped Upright
through Base opening.
Step 5
3 ¼ " Bolt
2 " Bolt
Back View
2 " Bolt 3 ¼ " Bolt
Front View