Poolmaster 72850 Pro-View Adjustable Height Poolside Basketball Game - Manual (Page 2)

Page 2
P.O. Box 340308
Sacramento, CA 95834-0308
ASSEMBLY INSTRUCTIONS:
PRO-VIEW
™
ADJUSTABLE HEIGHT
POOLSIDE BASKETBALL GAME
ITEM NO. 72850
© 2008 Poolmaster, Inc., Sacramento, CA 95834, U.S.A. Poolmaster is a registered trademark of Poolmaster, Inc. Need Assistance? Call our Toll Free Consumer Service Number:
1-800-854-1492. Visit us at our Website: http://www.poolmaster.com
Made in Malaysia
2. Base Assembly
• Insert bottom section of the upright pole
into the base (insert the end with the
larger diameter). Make sure the side
holes line up with the axle channel in the
base (FIGURE 3).
• Insert the (2) wheels into the base. When
facing the fron of the base, thread the
axle through the right wheel and then
into the side hole of the uphight pole and
then into the left wheel. Keep pushing
the axle until it hits the stop built into the
base and all parts are secure.
• Locate the right and left support braces
(they are not interchangeable)
(FIGURE 4). Align the holes in the (2)
support braces with the middle hole in
the upright pole. Secure with a 3" bolt,
(2) 5/6" washers, and lock nut. Secure
the bottom of the support braces to the
base with (2) 3/4" bolts and (2) 5/6"
washers, (2) lock nuts, and (2) /2"
washers.
• Place the upright pole’s top section onto
the bottom section. Align the holes in the
two sections and secure with a 2-3/4"
bolt, (2) 5/6" washers and lock nut.
• Fill base with water or sand and cover
opening with base cap. FOR BEST
RESULTS, USE SAND TO FILL BASE.
• WARNING: NO SLAM DUNKING! Place
NO SLAM DUNK label on front of base.
FIGURE 3
FIGURE 4