Poolmaster 72775 Water Basketball & Volleyball Comb - Manual (Page 3)

Base & Cap
PVC U-Shaped Base
Backboard Support
2" Bolt
2" Bolt
2" Bolt
3¼"Bolt
3¼"Bolt
PVC Support
PVC Support
Hex Nuts
Hex Nuts
2" Bolts
Inflation Needle
A
ssembly I
nstr
uc
tions
3
Step 4
• Attach two PVC Upright Supports
(with Caps on the bottom ends) to
the Backboard using four 2” Bolts
and secure with Hex Nuts
Step 5
• Undo the pre-threaded 2” Bolt and Hex Nut on the PVC U-Shaped Backboard Support (see Diagram
“A”) and thread the Bolt from the front of the backboard through the hole below the Backboard
Hoop Bracket into the lowest hole of the PVC U-Shaped Backboard Support. (see Diagram “B”).
Attach one 3¼” Bolt through the only remaining hole of the Backboard Hoop Bracket into the
upper hole of the PVC U-Shaped Backboard Support. Secure and tighten both Bolts with Hex Nuts.
Insert U-Shaped Support into Base (see Diagram “C”).
Step 7
• Place NO SLAM DUNK label
on front of Base
NO SLAM
DUNK label
poolmaster.com
Hex nuts
Step 6
• Use Ball Needle and hand pump (not
included) to inflate the Pro Style Ball
or the Water Sport Ball. Do not
over-inflate
Diagram A
Diagram B
Diagram C