Ridetech 13017199 - Manual (Page 5)

15. Check the length of the upper bar;
it should be 10" C-C. Bolt the axle tabs
to the upper bar with the larger tab to
the inside. Then place the other end
into the bridge. Both ends use a 5/8” x
2 3/4" and should not be fully tightened
yet.
16. Tack-weld the tabs to the axle then
recheck alignment. After removing the
upper bars the tabs can be welded
solid. To avoid warping the axle, weld
1” at a time and skip around.
17. Apply thread sealant to the air
fitting and screw it into the top of the
Shockwave.
18. Fasten the Shockwave to the
lower mount using the ½” x 2 ¼” bolt
and Nylok nut.
19. The 10” spacer can now be
removed.
20. With the axle still at ride height all
of the bolts can be tightened.
21. The stock exhaust tail pipe will not
work. A turndown may be installed or
a custom pipe may be fabricated.
22. Double-check
Shockwave/CoilOver clearance
through full suspension travel.
Failure to do so will cause failure
and is not a warrantable situation.
.