Ridetech 13027199 User Manual
Page 6
18. Insert a 5/8” x 4” bolt through the
upper mount and Shockwave eye.
There should be a 5/8” flat washer on
each side of the poly bushing and
one next to the head of the bolt.
Fasten the assembly with a 5/8”
Nyloc nut.
19. All of the bar mounts can now be
tightened.
20. Remove the 8 ½” spacer.
21. Ride height on this unit is 13”,
should be around 75 psi, but will vary
to vehicle weight and driver
preference.
22. To remount the brake line body
mount the 1” spacer is require to
allow clearance with the upper bar
mount. A longer 5/16” x 1 ¾” bolt, flat
washer and lock washer are also
supplied.
23. Double-check to make sure
nothing can rub the Shockwave at
any point through full suspension
travel.
Allowing the air spring to
rub will cause failure and is not a
warrantable situation.