Ridetech 12186799 - Manual (Page 5)

20. Bolt the air spring to upper
mount using a 3/8” x 1” bolt, lock
washer and flat washer.
21. Place the lower air spring plate
on top of the lower bridge. Fasten
the air spring to the bridge using a
3/8” x 1” bolt, lock washer and flat
washer. Do not allow the air
spring to rub on anything. This
will damage the unit and is not
warrantable situation
22. Ride height on this air spring is
around 10.5” tall, around 30 psi.
This may vary to driver preference
and vehicle weight.
17. Bolt the new shorter bump stop
to the frame using a 3/8” Nylok nut
and flat washer.
18. Bolt the shock absorber to the
upper mount using the bushing and
hardware kit supplied. A ½” x 2 ½”
bolt and Nylok nut will secure the
shock to the lower bridge.
19. Apply thread sealant to the air
fitting and screw it into the top of
the air spring.