Ridetech 11456799 User Manual
Page 7
IMPORTANT!!
The airspring can not rub on anything at anytime! Immediate failure may result!
17. The panhard bar can
now be installed. It is
adjusted at the factory to a
length of xx.xx. It should not
require re-adjustment, but
proper rearend centering
should be double checked.
The rubber bushed end will
be attached to the fixed
upper crossmember. The
spherical rod end will be
attached to the rear axle
bracket. As you can see in
the picture, clearances here
are tight. Run the
suspension through its full
suspension travel to double
check these clearances
upon final assembly.
18. The airsprings
can now [finally!] be
installed. Run the
suspension through
its entire travel to
ensure there is no
contact with the
airspring and any
obstructions. The
picture to the left
gives an overall view
of the installation
and the routing of
brakelines, wiring,
and fuel lines.
Double check
clearances on these
items upon final
assembly.