Ridetech 19002003 - Manual (Page 3)

Pro Street lower bracket / under-frame bracket:
The “Pro street” lower bracket is designed to drop the airspring 4” below the axle tube. This will
accommodate a rear suspension that is very compact [such as a pro street vehicle] or that requires that
the airspring be below the frame rail. This bracket also incorporates the lower 4-link mount and/or the
lower shock mount.
The upper mount is often best located under the frame rail. Our under frame bracket is fastened to the
side of the frame rail and is configured to mount the airspring under the frame rail. This bracket may also
be turned around to mount the airspring slightly beside the frame rail.
DIMENSION CHART
Ride Height
A
B
Top
air inlet
Bottom
Compressed Extended
Double
Convoluted
Tapered
Sleeve
Top
Sleeve
Rolling
Top
AIRSPRING DIMENSION CHART
PART# TYPE Capacity
@100psi
Compres
s Height
Ride Height Max.
Height
Max
Diameter
Bolt Pattern
255C
[F6957]
Double
Convoluted
2040# 3” 5”-6” 7” 6.5” A=1.75 B=.875
224C
[F0335
Double
Convoluted
3150# 3” 5”-6” 8” 8.0” A=2.75 B=1.312
26C
[F7325]
Double
Convoluted
3400# 3” 5”-6” 10” 8.5” A=2.75 B=1.312
20
[F6908]
Double
Convoluted
4790# 3” 7”-8” 11” 9.9” A=3.50 B=1.75
F2107 Rolling Sleeve 4000# 6” 9” - 12” 16” 9” A=3.50 B=1.75
F9000 Tapered Sleeve 1500# 4.5 8-9”” 13” 5” A=2.75 B=1.312
F9002 Tapered Sleeve 1500# 4.5 7-7.5” 12” 5” A=2.75 B=1.312
F9003 Tapered Sleeve 1500# 4.5 6.5-7” 11” 5” A=2.75 B=1.312
F9010 Tapered Sleeve 2000# 6.5” 10.5”-11.5” 16” 6.5” .750 SAE/.250npt
7012 Rolling Sleeve 1020# 4” 7.5”-8.5” 13” 5” .750SAE/.125npt
7076 Rolling Sleeve 800# 3.5” 5”-6” 9” 4” .750SAE/.125npt
CAUTION!!! EXCEEDING THESE DIMINSIONS MAY RESULT IN SUDDEN AIRSPRING FAILURE!
PROPER CLEARANCES MUST BE MAINTAINED AT ALL RIDE HEIGHTS AND STEERING ANGLES.
BUMPSTOPS MUST BE USED TO LIMIT SUSPENSION TRAVEL BEFORE THESE DIMENSIONS
ARE EXCEEDED.PLEASE CALL AIR RIDE TECHNOLOGIES IF YOU HAVE ANY QUESTIONS.
812.482.2932