Ridetech 11326110 - Manual (Page 2)

Installation Instructions
1. Raise and safely support the vechile by the frame rails.
2. Using a jack, slightly raise the axle approximately 1”. Remove the shock absorbers.
3. Lower the axle down enough to remove the coil springs.
4. The exhaust tail pipes may need to be removed and/or modified for Shockwave installation.
5. Fasten the new upper shock
bracket into the factory shock
location using the 5/16” x 1” bolts, flat
washers and Nylok nuts supplied.
Note: Position the bracket to offset
the shock toward the center of the
car.
6. Remove the lower trailing arm
mounting bolt. (Do one side at a
time to keep the axle from rotating).
7. Place the new lower shock
bracket up against the factory lower
shock bracket. Use a ½” x 1 ½” bolt,
Nylok nut and flat washers to fasten
the new bracket to the factory
bracket. Install the longer ½” x 3 ¾”
bolt through the lower trailing arm
mount, secure w/ the supplied flat
washers and Nylok nuts.