Movies2Go MM801 - Manual (Page 8)

Installation Guide
8
1) Insert the Circular Mini-Din Connector of the source Component Harness through the wire tie loop
on the main PCB and into the Mini-Din Connector on the main PCB.
2) Pull the wire tie loop tight and cut off the excess.
3) Connect the Power Harness to the mating connector on the Video Monitor.
4) Connect the power harness to the vehicle’s electrical system through an In-Line 5-Ampere fuse by
tapping into an accessory hot line.
5) Verify all functions of the System before final mounting of the finished assembly.
MM801
1
Red RCA (Audio Right)
White RCA (Audio Left)
Yellow RCA (Video)
Power
Connector 4 Pin
IR LED:
Clean the IR Receiver Window on the front of the VCP.
Remove Adhesive Backing and Apply IR LED to IR
Window on the Face of the VCP. “Y” Adapter
for use with
Non-Stereo
Installations
Accessory
Harness
item #7
ANT.IN
RF OUT
OUT
FUSE
DC IN
Power Harness
item #5
Red: +12VDC
Accessory Ckt.
(Install 5A
Inline Fuse)
Black: Ground
Dome
Light
Audio Output
forFM Mod.
Video Output