Ridetech 12121099 User Manual

Page 3

Advertising
background image

9. Fasten the air spring to the lower
plate using a 3/8” x 1” bolt, lock washer
and flat washer.

10. Reattach the sway bar end link to
the lower control arm.

11. Check air spring clearance
through full suspension travel.
Allowing the air spring to rub will
result in failure and is not a
warrantable situation.

12. Ride height on this air spring is
approximately 5” tall. This may vary to
driver preference.

8. Fasten the air spring assembly to
the frame in place of the coil spring,
using a 7/16” nut and flat washer. The
air fitting access should face toward
the engine.
It may be easier to use a
needle nose pliers to get the nut
started on the stud.

Note: The airline must be routed at
this time.

Advertising