Ridetech 12060999 User Manual
Page 2
Installation Instructions for ARF10900-LCA
1. Raise the vehicle to a safe and comfortable working height. Support the vehicle by the
frame so that the suspension can hang freely.
2. Remove the coil spring, lower control arm and shock absorber. Refer to factory service
manual for disassembly procedures.
3. The inner fender well shield next to the upper control arm and the factory brake line frame
bracket must also be removed.
4. Remove the factory upper shock
mount. The front of it is held in with two
rivets that must be ground down and
pushed out. In its place install the
upper air spring mounting plate & shim.
The shim will go under the front side of
the plate and is secured with two 3/8” x
1 ½” bolts, flat washers, nuts and lock
washers. The rear side of the plate will
be secured with one 3/8” x 1 ¼” bolt
flat washer and lock washer.
5. Apply thread sealant to a straight air
line fitting and screw it into the top of
the air spring. Fasten the air spring to
the upper mount using two 3/8” Nylok
nuts and flat washers.