Installation instructions – Ridetech 11381099 User Manual
Page 2
350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
Installation Instructions
*** Must use RideTech Front Shock Kit ***
2. Install the lower air spring
mounting plate into the lower
control arm using the oem sway bar
attachment hole as the primary
locater. The remaining attachment
holes will then be drilled so the
plate can be securely fastened to
the control arm.
3. The sway bar end link must be
shortened by approx. 2”. A new
shorter bolt is provided, but the
sleeve must be cut by the installer.
Doing this will re-align the sway bar
for proper clearance and
effectiveness.
1. The upper coil spring bucket
must be trimmed for air spring
clearance. The trimmed piece will
measure approx. 1 3/4 x 1 3/4. A
die grinder and a cutoff wheel will
do the job nicely. The objective
here is to create clearance for the
air spring. Check this area VERY
carefully for abrasion against air
spring.