Ridetech 11370999 - Manual (Page 2)

Installation Instructions
*** Must Use RideTech Front Shock Kit ***
1. Apply thread sealant to the air fitting
and screw it into the air spring.
Assemble the upper cup bracket to the
air spring, using 3/8” Nylok nuts and flat
washers. Thread the 8” stud into nut
welded to the bottom of the cup.
2. Place the assembly up into the
upper coil spring pocket; the stud will
go though the factory shock hole.
Fasten with a 7/16” Nylok nut and flat
washer.
Note: The airline must also be routed
at this time.
3. Fasten the bottom of the air spring
to the lower StrongArm using a 3/8” x
¾” bolt, lock washer and flat washer.