Ridetech 11330999 - Manual (Page 2)

Installation Instructions
******Must be used w/ RideTech shock kit******
1. Hold the upper plate to the cross
member as shown in the picture to the
left and clamp to frame. Using the
plate as a template drill four 3/8” holes
in the cross member.
2. Apply thread sealant to the air fitting
and thread into the air spring.
3. Remove the upper plate from the
frame and place onto the studs on the
top of the air spring. The holes are
lettered; slide the plate to position C
moving the air spring to the front of the
vehicle. Secure with 3/8” flat washers
and Nylok nuts.
Note: Airline must be routed at this
time.