Ridetech 11324099 User Manual
Page 2
Installation Instructions
1. Raise and support vehicle at a safe and comfortable working height.
2. Support the axle then remove the coil spring and shock. Refer to service manual for proper
disassembly procedure. To help keep the axle in place, do one side at a time.
*** Must Use RideTech Rear Shock Kit ***
3. Apply thread sealant to a 90 deg.
air fitting and screw it into the top of
the air spring.
4. Place the upper air spring bracket
on top of the air spring and secure
with two 3/8” x 3/4" bolts, flat
washers, and lock washers.
5. Thread the 2” stud into the nut in
the bottom of the bracket.
6. Hold the air spring assembly up to
the coil spring pocket with the stud
protruding through the hole in the
center of the coil spring pocket.
Place the 4” diameter washer over
the stud and tighten with a 7/16”
Nyloc nut and flat washer.
Note: Some cars have a small hole
in the frame and will not need the 4”
washer.