Ridetech 11336799 User Manual
Page 6
14. The upper air spring plate is built
into the notch. But the two inner 3/8”
holes will need to be into the frame
using the notch as a template.
15. A 1” x 1” portion of the frame
must be removed for air fitting
clearance. (Shown in the picture to
the left).
16. Install the medium bump stops
into the notch. A 3/8” Nylok nut and
flat washer will secure it. This picture
is shown with the short bump stop.
Note: If you wish to lower the vehicle
an additional 1” you can install a
shorter bump stop, but this will
require cutting the bed floor to allow
clearance for the differential housing.
(Also requires a shorter shock part#
MON33033 & ½” lower studs.)
Note: Check bed to differential
housing clearance. A couple
washers may be required between
the bump stop and notch to provide
adequate clearance.
17. The new upper shock bridge is
bolted in place using 6- 7/16” x 1 ¼
bolts, Nylok nuts and flat washers
between the notches on the bottom
side of the frame rail.
Note: There are four holes on each
side of the bridge; only 3 will be used.