Ridetech 11214099 User Manual
Page 2
1. Raise and support vehicle at a safe and comfortable working height.
2. Support the axle then remove the shock absorber, coil spring, and upper coil spring rubber.
Refer to service manual for proper disassembly procedure
.
It is easier to do one side at a
time. You will have to pull the axle down to slip the coil spring out.
*** Must Use Factory Length Shocks ***
3. Apply thread sealant to a 90
degree air fitting and screw it into the
top of the air spring.
4. Fasten the upper mount to the air
spring with two 3/8” x ¾” bolts, flat
washers and lock washers.
5. This hole in the inner fender must
be enlarged to 3/8”.
6. The 3/8” Carriage bolt, Nylok nut
and flat washer will fasten the upper
bracket to the coil spring pocket.