Ridetech 11151099 - Manual (Page 2)

Installation Instructions
*** Must Use RideTech Front Shock Kit ***
1. Apply thread sealant to the air
fitting and screw it into the top of the
air spring.
2. Place the upper cup bracket on
top of the air spring and secure w/
two 3/8” Nylok nut and flat washers.
3. Fasten the lower bracke to the
bottom of the air spring using a 3/8” x
3/4" bolt, lock washer and flat
washer.
4. Screw the 8” all-thread stud into
the nut at the bottom of the cup.
5. Place the assembly into the coil
spring pocket with the stud sticking
through the factory shock hole.
Install 7/16” flat washer and Nylok nut
onto stud.
6. The lower air spring bracket will
simple rest in the coil spring pocket in
the lower arm. The bracket may
need to be rotated to achieve proper
air spring alignment. The tall side of
the bracket should be clocked toward
the spindle.
7. Check air spring clearance
throughout full suspension travel.
Allowing the air spring to rub will
result in failure and is not a
warrantable situation.
8. Ride height on this air spring is
between 4.5” – 5.5” tall.