Ridetech 11154099 User Manual
Page 3
Airspring
Axle Tube
Frame
Airspring
Plate
Airline
Washer
Lower
Washer
Upper
7. Place the air spring plate over the
lower coil spring mount on the axle.
Extend the air spring so the bottom of
it seats on top of the plate. Some
cars will require trimming of the coil
spring retainer to allow this.
8. Use the 3/8” x 1 ¼” bolt and 2.5”
washer to secure the air spring to the
axle.
9. Install the new shocks using the
hardware supplied.
10. Check air spring clearance with
exhaust and anything else that could
rub against it. Abrasion will cause
air spring failure and is not a
warrantable situation.
11. Driving height on this air spring is
8 ½”-9” tall. Maximum extended
height is 12”, minimum compressed
height is 4 ½”. Allowing this air
spring to exceed these dimensions
will cause failure. The shock
absorber and factory bump stop
should keep the air spring within
these limits.