Ridetech 11134099 - Manual (Page 2)

Installation Instructions
1. Raise and support vehicle at a safe and comfortable working height.
2. Support the axle then remove the coil spring and shock. Refer to service manual for proper
disassembly procedure. The studs in the upper coil spring mount must be removed. To help keep
the axle in place, do one side at a time.
*** For Use With RideTech Shock Kit ***
3. Apply thread sealant to a straight air
fitting and screw it into the top of the air
spring.
4. Place the upper cup (tall) on top of
the air spring and fasten with two 3/8”
Nyloc nuts and flat washers. Thread
the 8” stud into the nut in the bottom of
the cup. The upper cup cap (short) will
sit on top with the flat plate on top. The
airline must be routed at this time. The
assembly will be secured to the upper
coil spring mount with the large washer
and a7/16” Nyloc nut and flat washer
as shown in the picture.
5. Place the lower air spring plate on
top of the lower arm. Raise the axle up
to the air spring and fasten with a
3/8” x 1” bolt, lock washer and flat
washer.
6. Install the new shock absorbers.
7. Ride height on this air spring is
approximately 5” tall. This may vary to
driver preference.